Question

mj: support structures. use the information below to answer the question. in material jetting (mj), there is the capability of having two materials printed at once, one being the build material; the other being a dissolvable support structure. it has some similarities to the fused filament fabrication process that uses a print head. the printing for the build material and the support structure can run concurrently. this is dictated by the slicing software to make sure they dont cross. the software also determines if there would be a conflict over the build plate. it might discontinue printing with one head and continue with the other to ensure that the two dont run over each other in the printing process. another aspect of material jetting (mj) is the form the structure takes. it is one solid form, using up less material such as that used in sla. removing the support structure: the support structures are dissolvable. the form is put in an ultrasonic bath to help dissolve and break down the support structure. the ultrasonic bath has a high amount of energy that can break down the structure so there is less opportunity for damaging the surface. there is minimal surface imperfection. it has a high - detail finish, which makes it good for cast jewelry making. with the ability to print two materials at once, it is a good solution if you need minimal surface damage to your forms. what form do material jetting (mj) prints take? hollow, lightweight forms multiple smaller forms flat, 2d forms one solid form

Explanation:

The text states that "One aspect of Material Jetting (MJ) is the form the structure takes. It is one solid form".

Answer:

one solid form