operating a toothed section jack stand\nraising\nthe cup of a toothed section jack stand can be raised by…

operating a toothed section jack stand\nraising\nthe cup of a toothed section jack stand can be raised by... cause it to drop and stop at the next locking point.\nlocking\nthis type of axle stand is locked when the cam in the top of the jack stand slides into the toothed section, preventing the cupped section from dropping further. if the cup is at the correct height, the steel pin is inserted as an extra lock.\nlowering\ncheck that the vehicle weigh is not sitting on the jack stand, before lowering the cup. if the cup needs to be lowered, the steel pin needs to be removed from the jack stand. then hold the cup with one hand and move the steel handle upwards using your other hand. the cup can now be eased down.\nthe jack stand cup is at the required height.\nwhat should you do now?\ninsert the locking pin.\nlower the vehicle onto the jack stand.\nmove the steel handle upwards.\ncheck

operating a toothed section jack stand\nraising\nthe cup of a toothed section jack stand can be raised by... cause it to drop and stop at the next locking point.\nlocking\nthis type of axle stand is locked when the cam in the top of the jack stand slides into the toothed section, preventing the cupped section from dropping further. if the cup is at the correct height, the steel pin is inserted as an extra lock.\nlowering\ncheck that the vehicle weigh is not sitting on the jack stand, before lowering the cup. if the cup needs to be lowered, the steel pin needs to be removed from the jack stand. then hold the cup with one hand and move the steel handle upwards using your other hand. the cup can now be eased down.\nthe jack stand cup is at the required height.\nwhat should you do now?\ninsert the locking pin.\nlower the vehicle onto the jack stand.\nmove the steel handle upwards.\ncheck

Answer

Brief Explanations:

According to the "Locking" section in the operating instructions, when the cup of the toothed - section jack stand is at the correct height, the steel pin is inserted as an extra lock. Also, after the height is set, the next step is usually to lower the vehicle onto the jack stand. Moving the steel handle upwards is for lowering the cup, which is not the action to take when the height is already set.

Answer:

Insert the locking pin. Lower the vehicle onto the jack stand.