operating a tubular sectioned axle stand\nthe locking mechanism may vary on the different types of jack…

operating a tubular sectioned axle stand\nthe locking mechanism may vary on the different types of jack stands.\nraising\nmove the cup upwards, until the section with the hole in the jack stand.\nlocking\nthe cup is locked by inserting the steel pin through the holes in the jack stand and the holes in the tubular section.\nlowering\ncheck that the vehicle is not sitting on the jack stand, before you lower the cup. hold the cup or the tubed section with one hand; use your other hand to remove the locking pin and lower the cup.\ntake care to not get your hand caught between axle stand and cup!\nhow is the cup on a tube sectioned jack stand raised to the intended height?\nuse one hand to raise the cup to the intended height; use your other hand to fit the locking pin.\nthe tube is freed inside the stand by twisting the cup a quarter turn. this pipe can now be set at the required height by turning it.\nuse two hands to pull the cup upwards; friction in the jack stand will cause the cup to remain at the correct height.

Answer