technician a says that to engage the feed clutch you must pull out on the feed dial knob. technician b says…

technician a says that to engage the feed clutch you must pull out on the feed dial knob. technician b says that for safety reasons, you should shut the lathe down when installing the chip deflector/silencer. who is correct?\ntechnician a\ntechnician b\nboth technician a and technician b\nneither technician a nor technician b

technician a says that to engage the feed clutch you must pull out on the feed dial knob. technician b says that for safety reasons, you should shut the lathe down when installing the chip deflector/silencer. who is correct?\ntechnician a\ntechnician b\nboth technician a and technician b\nneither technician a nor technician b

Answer

Brief Explanations:

Technician A's statement about engaging the feed clutch by pulling out on the feed dial knob is a common - practice in lathe operation. Technician B's statement about shutting down the lathe for safety when installing the chip deflector/silencer is also a valid safety measure.

Answer:

C. Both Technician A and Technician B