worn outer tie - rod ends should be removed from the steering arm/knuckle by all of the following except: a…

worn outer tie - rod ends should be removed from the steering arm/knuckle by all of the following except: a. removing the cotter pin in the stud and nut. b. removing the nut from the threads. c. using the special puller tool to press it out of the taper. d. heating the arm with a torch to expand the hole diameter.

worn outer tie - rod ends should be removed from the steering arm/knuckle by all of the following except: a. removing the cotter pin in the stud and nut. b. removing the nut from the threads. c. using the special puller tool to press it out of the taper. d. heating the arm with a torch to expand the hole diameter.

Answer

Brief Explanations:

Removing the cotter - pin, nut, and using a puller are common and proper methods for removing worn outer tie - rod ends. Heating the arm with a torch to expand the hole diameter is an improper and potentially damaging method as it can cause warping, change material properties, and may not be necessary for this removal.

Answer:

D. Heating the arm with a torch to expand the hole diameter