Question

1. the knot shown in the figure above is a

a. square knot
b. clove hitch
c. half hitch
d. bowline

1. one common way to tie a clove hitch is to use two

a. slip knots
b. half hitches
c. square knots
d. bowlines

1. when moving a material cart on an inclined or declined surface, be sure the

a. load does not exceed the labeled weight capacity
b. hand brake is within your reach
c. hydraulic ram has been removed
d. load is cushioned with moving pads to prevent slippage

1. to transport a bottle of compressed gas, use a

a. hand truck
b. cylinder cart
c. wheelbarrow
d. tunnel buggy

1. what device may have a rotating table surface and/or spikes on the table surface for a better

a. roller skid
b. pallet jack
c. pallet conveyor
d. accumulating conveyor

1. to work with motorized material - handling equipment, a worker must be

a. trained, certified, and authorized
b. experienced and knowledgeable
c. a job foreman or supervisor
d. licensed to drive

Explanation:

• For question 6, the knot shown is a clove - hitch based on its structure.
• For question 7, a clove - hitch is commonly tied using two half - hitches.
• For question 8, when moving a material cart on an inclined surface, the hand - brake should be within reach for safety.
• For question 9, a cylinder cart is used to transport compressed gas bottles.
• For question 10, a roller skid may have a rotating table surface and/or spikes.
• For question 11, to operate motorized material - handling equipment, a worker must be trained, certified, and authorized.

Answer:

1. b. clove hitch
2. b. half hitches
3. b. hand brake is within your reach
4. b. cylinder cart
5. a. Roller skid
6. a. trained, certified, and authorized