Question

true or false
directions: read each statement carefully. if the statement is true, write true in the blank to the left of the numbered item. if the statement is false, write false in the blank.
______ 14. one of the purposes of a planer is to straighten a warped board.
______ 15. the cutting head is mounted below the table, so when you pass stock through the planer, only the bottom of the stock is surfaced.
______ 16. you should always stand to one side when planing stock; never directly behind the board.
______ 17. when tailing off, pull gently on the board being planed to help it move through the planer smoothly.
______ 18. to surface several short pieces of the same thickness, butt the ends together as they are fed through the planer.
step - by - step procedures: using the planer
directions: match each item in column i with the correct step number in column ii. write the letter in the blank at the left of each numbered item.
column i column ii
______ 19. turn on the power and engage the feed control. a. step 1
b. step 2
c. step 3
d. step 4
e. step 5
f. step 6
g. step 7
______ 20. adjust the machine to 1/16 to 1/8 less than the thickness of the board at its thickest point.
______ 21. check the stock and then reset for thickness if another cut is to be made.
______ 22. measure the thickness of the board at its thickest point.
______ 23. start the stock into the planer and remove your hands.
______ 24. walk around to the back and hold the surfaced end of the board up as the remainder of the board passes through the machine.
______ 25. place the working face of the stock on the table so that it feeds with the grain.

Explanation:

Answer:

1. False
2. False
3. True
4. True
5. True
6. D. Step 4
7. B. Step 2
8. G. Step 7
9. A. Step 1
10. E. Step 5
11. F. Step 6
12. C. Step 3